Feed Rate Mode G-codes (G93, G94, and G95)

Last modified: February 8, 2024

CNCCookbook’s G-code Tutorial

G93 G-code:  Inverse Time

Inverse time mode is used to program simultaneous coordinated linear and rotary motion.  It basically causes F (the feedrate command) to cause a move to be completed in 1/F minutes.  So, if F is 2.0, the move should be completed in 30 seconds.

When inverse time mode is active, an F word must be present on every line that has a G01, G02, or G03.  G93 does not affect G00 motion.

G94 G-code:  Feedrate Units Per Minute

In the Units per Minute mode, the F word causes motion in units per minute.  When the G-code is set to Imperial mode, the units will be inches per minute.

G94 is what most will regard as the "normal" feed rate mode.

G95 G-code:  Feedrate Units Per Revolution

G95 is convenient for programming chip loads on lathes.  It causes the motion to be in units per spindle revolution.

Next Article:  Cracking the Code: G28 G-code for Machinists

Be the first to know about updates at CNC Cookbook

Join our newsletter to get updates on what's next at CNC Cookbook.